High Frequency Model of Cables for Frequency Domain Analysis used for Fault Localization

authored by

Younes Norouzi, C. Frohne, Peter Werle

Abstract

In order to develop a new method for the detection and Iocalization of faults in long cable systems, it would be beneficial to develop a numerical model for a cable in order to simulate the possible fault scenarios. In this regard, a simulation model using MATLAB / SIMULINK is established. This model provides the response and behavior of a cable system to sweep frequency signals. It is programmed for a broad range of cable parameters.To verify the simulation model, the results are compared to those experimentally measured results on a real cable. The emerging deviations in FDA response are attributed to the corresponding fault mode.

Organisation(s)

High Voltage Engineering and Asset Management Section (Schering Institute)
Institute of Electric Power Systems

External Organisation(s)

Nexans Deutschland GmbH

Type

Conference contribution

No. of pages

4

Publication date

09.2019

Publication status

Published

Peer reviewed

Yes

ASJC Scopus subject areas

Energy Engineering and Power Technology, Electrical and Electronic Engineering

Electronic version(s)

https://doi.org/10.1109/ICHVE.2018.8641904 (Access: Closed)